ST-1509 Digital Soldering Station
150W high power soldering station with LCD display
Using integrated soldering tips, rapid heating. Pluggable heater design, easy to replace. 3 sets of shortcut temperature to simplify operations. Support and switchable. Support temperature lock, temperature calibration, temperature alarm function, etc. Auto standby and sleep function, conserves energy and protect equipment. Password-protected function to preserve settings. Compatible with Y950/Y9130/Y9150/N9100 handles.
info
Easy Replacement of Heating Element Putting the handle into the stand slot to pull its integrated heater out, then put the integrate heater in the hole of stand.
Easy Temperature SettingUnder normal work, press “ ” or “ ” button to adjust temperature value. Long pressing can be quickly adjusted. After stop pressing for 3 seconds, data saved.
save frequently used temperature.Press “1 or 2 or 3” button to quickly preset temperature value; Long press “1 or 2 or 3” button ( more than 3 seconds ) to store temperature value.
Temperature lock function C/F is available and exchangeable.
Temperature calibration. Calibration range -50 ~50 /-90 ~90 . When the real temperature is lower than the display temperature, the compensation takes a negative temperature value. When the real temperature is higher than the display temperature, take a positive temperature value.
Auto-standby function
Under the STB menu, press " " and " " to set the standby parameters: Off/On time 10~60 (default 1) minutes. The heater temperature is 150 under standby status. In standby mode, pick up the soldering tool or press any key to automatically resume normal operation. (Note: If the device is not in a static state, it will affect the device to enter auto sleep.)
Auto-sleep function Note: The auto sleep function needs to be used when the auto standby function is turned on. When the auto standby function is turned off, the auto sleep function is turned off at the same time. The auto sleep function cannot be turned off when the auto standby function is turned on. Under the OFF menu, press " " and " " button can be set the heating time 10~60 (default 30) minutes. When the heating state is turned off, pressing any button will automatically resume the normal working mode.
Beep alarm function available
Upper /lower temperature alarm function It will alarm if soldering iron temperature higher or lower then the set alarm temperature. The upper and lower temperature rang is ±20 to 80 °C.
Password Protection The password data can be set from “01” to “999”. Fault alarm function Display S-E is a sensor fault; H-E is a heater core fault
| Specifications | |
|---|---|
| Model | ST-1509 |
| Power consumption | 150W |
| Input voltage | 110VAC/220VAC ±10% 50Hz/60Hz |
| Output voltage | 24VAC |
| Temperature range | 80 ~480 /176 ~896 |
| Temperature offset range | ±50 (±90 ) |
| Temperature stability | ±1 at idle temperature |
| Tip to ground resistance | <2Ω |
| Tip to ground potential | <2mV |
| Auto-sleep | 0~60 minutes (Default 1 minutes) |
| Auto turn off the heating | 0~60 minutes (Default 30 minutes) |
| Temperature accuracy | ±10 |